Cc2541 emulator CC debugger tutorial

One 、 brief introduction

This paper introduces CC2541 Of Simulation device CC Debugger Debug Download for Interface 、 use CC Debugger Realization SnIFfer Packet The steps of capturing bags 、CC Debugger Easy steps for firmware download .

CC-Debugger yes ti A new generation CC series chip Emulator for , In addition to debugging the simulator of the chip , It can also be used as Sniffer Packet Protocol Analyzer .

 

Two 、CC Debugger Debug Download Interface

Sum up , In download mode , Development board CC254x End and CC Debugger attachment ：DC、DD、RESET、GND、VCC（ Development board CC254x In case of independent power supply , Not necessary CC Debugger Of VCC Power supply ）.

notes ：CC Debugger Of 2 and 9 The pin needs to be short circuited , To recognize CC254x.

 

3、 ... and 、CC Debugger Realization Packet sniffer

notes ：CC Debugger Can not be like USB Dongle To capture packets independently .

It needs to be implemented in this way ：CC Debugger+CCXXXX（ Burn it Sniffer Packet The firmware ）.

among CCXXX Refer to ：

 

The next step is to CC Debugger+CC2540（smart RF Development board ） For example ：

1） Write to the development board Sniffer Packet The firmware

Firmware address ：C:\Program Files\Texas Instruments\SmartRF Tools\Packet Sniffer\bin\general\firmware\sniffer_fw_cc2540.hex

Download a software ：flash programmer

 

2） use Sniffer Packet Software capture package

 

Four 、CC Debugger Easy steps for firmware download

Someone else wrote , Just take a screenshot , Attach the author's name ~